2
0
mirror of https://github.com/openvswitch/ovs synced 2025-08-22 18:07:40 +00:00
ovs/ofproto/fail-open.c

254 lines
8.1 KiB
C
Raw Normal View History

/*
* Copyright (c) 2008, 2009, 2010, 2011 Nicira Networks.
*
* Licensed under the Apache License, Version 2.0 (the "License");
* you may not use this file except in compliance with the License.
* You may obtain a copy of the License at:
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*/
#include <config.h>
#include "fail-open.h"
#include <inttypes.h>
#include <stdlib.h>
#include "classifier.h"
#include "connmgr.h"
#include "flow.h"
#include "mac-learning.h"
#include "odp-util.h"
#include "ofp-util.h"
#include "ofpbuf.h"
#include "ofproto.h"
#include "pktbuf.h"
#include "poll-loop.h"
#include "private.h"
#include "rconn.h"
#include "timeval.h"
#include "vconn.h"
#include "vlog.h"
VLOG_DEFINE_THIS_MODULE(fail_open);
/*
* Fail-open mode.
*
* In fail-open mode, the switch detects when the controller cannot be
* contacted or when the controller is dropping switch connections because the
* switch does not pass its admission control policy. In those situations the
* switch sets up flows itself using the "normal" action.
*
* There is a little subtlety to implementation, to properly handle the case
* where the controller allows switch connections but drops them a few seconds
* later for admission control reasons. Because of this case, we don't want to
* just stop setting up flows when we connect to the controller: if we did,
* then new flow setup and existing flows would stop during the duration of
* connection to the controller, and thus the whole network would go down for
* that period of time.
*
2010-04-07 12:57:21 -07:00
* So, instead, we add some special cases when we are connected to a
* controller, but not yet sure that it has admitted us:
*
* - We set up flows immediately ourselves, but simultaneously send out an
* OFPT_PACKET_IN to the controller. We put a special bogus buffer-id in
* these OFPT_PACKET_IN messages so that duplicate packets don't get sent
* out to the network when the controller replies.
*
* - We also send out OFPT_PACKET_IN messages for totally bogus packets
* every so often, in case no real new flows are arriving in the network.
*
* - We don't flush the flow table at the time we connect, because this
* could cause network stuttering in a switch with lots of flows or very
* high-bandwidth flows by suddenly throwing lots of packets down to
* userspace.
*/
struct fail_open {
struct ofproto *ofproto;
struct connmgr *connmgr;
int last_disconn_secs;
long long int next_bogus_packet_in;
struct rconn_packet_counter *bogus_packet_counter;
};
static void fail_open_recover(struct fail_open *);
/* Returns the number of seconds of disconnection after which fail-open mode
* should activate. */
static int
trigger_duration(const struct fail_open *fo)
{
if (!connmgr_has_controllers(fo->connmgr)) {
/* Shouldn't ever arrive here, but if we do, never fail open. */
return INT_MAX;
} else {
/* Otherwise, every controller must have a chance to send an
* inactivity probe and reconnect before we fail open, so take the
* maximum probe interval and multiply by 3:
*
* - The first interval is the idle time before sending an inactivity
* probe.
*
* - The second interval is the time allowed for a response to the
* inactivity probe.
*
* - The third interval is the time allowed to reconnect after no
* response is received.
*/
return connmgr_get_max_probe_interval(fo->connmgr) * 3;
}
}
/* Returns true if 'fo' is currently in fail-open mode, otherwise false. */
bool
fail_open_is_active(const struct fail_open *fo)
{
return fo->last_disconn_secs != 0;
}
static void
send_bogus_packet_ins(struct fail_open *fo)
{
uint8_t mac[ETH_ADDR_LEN];
struct ofpbuf *opi;
struct ofpbuf b;
/* Compose ofp_packet_in. */
ofpbuf_init(&b, 128);
eth_addr_nicira_random(mac);
compose_benign_packet(&b, "Open vSwitch Controller Probe", 0xa033, mac);
opi = make_packet_in(pktbuf_get_null(), OFPP_LOCAL, OFPR_NO_MATCH, &b, 64);
ofpbuf_uninit(&b);
/* Send. */
connmgr_broadcast(fo->connmgr, opi);
}
/* Enter fail-open mode if we should be in it. */
void
fail_open_run(struct fail_open *fo)
{
int disconn_secs = connmgr_failure_duration(fo->connmgr);
/* Enter fail-open mode if 'fo' is not in it but should be. */
if (disconn_secs >= trigger_duration(fo)) {
if (!fail_open_is_active(fo)) {
VLOG_WARN("Could not connect to controller (or switch failed "
"controller's post-connection admission control "
"policy) for %d seconds, failing open", disconn_secs);
fo->last_disconn_secs = disconn_secs;
/* Flush all OpenFlow and datapath flows. We will set up our
* fail-open rule from fail_open_flushed() when
* ofproto_flush_flows() calls back to us. */
ofproto_flush_flows(fo->ofproto);
} else if (disconn_secs > fo->last_disconn_secs + 60) {
VLOG_INFO("Still in fail-open mode after %d seconds disconnected "
"from controller", disconn_secs);
fo->last_disconn_secs = disconn_secs;
}
}
/* Schedule a bogus packet-in if we're connected and in fail-open. */
if (fail_open_is_active(fo)) {
if (connmgr_is_any_controller_connected(fo->connmgr)) {
bool expired = time_msec() >= fo->next_bogus_packet_in;
if (expired) {
send_bogus_packet_ins(fo);
}
if (expired || fo->next_bogus_packet_in == LLONG_MAX) {
fo->next_bogus_packet_in = time_msec() + 2000;
}
} else {
fo->next_bogus_packet_in = LLONG_MAX;
}
}
}
/* If 'fo' is currently in fail-open mode and its rconn has connected to the
* controller, exits fail open mode. */
void
fail_open_maybe_recover(struct fail_open *fo)
{
if (fail_open_is_active(fo)
&& connmgr_is_any_controller_admitted(fo->connmgr)) {
fail_open_recover(fo);
}
}
static void
fail_open_recover(struct fail_open *fo)
{
struct cls_rule rule;
VLOG_WARN("No longer in fail-open mode");
fo->last_disconn_secs = 0;
fo->next_bogus_packet_in = LLONG_MAX;
cls_rule_init_catchall(&rule, FAIL_OPEN_PRIORITY);
ofproto_delete_flow(fo->ofproto, &rule);
}
void
fail_open_wait(struct fail_open *fo)
{
if (fo->next_bogus_packet_in != LLONG_MAX) {
poll_timer_wait_until(fo->next_bogus_packet_in);
}
}
void
fail_open_flushed(struct fail_open *fo)
{
int disconn_secs = connmgr_failure_duration(fo->connmgr);
bool open = disconn_secs >= trigger_duration(fo);
if (open) {
union ofp_action action;
struct cls_rule rule;
/* Set up a flow that matches every packet and directs them to
* OFPP_NORMAL. */
memset(&action, 0, sizeof action);
action.type = htons(OFPAT_OUTPUT);
action.output.len = htons(sizeof action);
action.output.port = htons(OFPP_NORMAL);
cls_rule_init_catchall(&rule, FAIL_OPEN_PRIORITY);
ofproto_add_flow(fo->ofproto, &rule, &action, 1);
}
}
/* Creates and returns a new struct fail_open for 'ofproto' and 'mgr'. */
struct fail_open *
fail_open_create(struct ofproto *ofproto, struct connmgr *mgr)
{
struct fail_open *fo = xmalloc(sizeof *fo);
fo->ofproto = ofproto;
fo->connmgr = mgr;
fo->last_disconn_secs = 0;
fo->next_bogus_packet_in = LLONG_MAX;
fo->bogus_packet_counter = rconn_packet_counter_create();
return fo;
}
/* Destroys 'fo'. */
void
fail_open_destroy(struct fail_open *fo)
{
if (fo) {
if (fail_open_is_active(fo)) {
fail_open_recover(fo);
}
/* We don't own fo->connmgr. */
rconn_packet_counter_destroy(fo->bogus_packet_counter);
free(fo);
}
}