OpenFlow 1.0 adds support for matching on IP ToS/DSCP bits.
NOTE: OVS at this point is not wire-compatible with OpenFlow 1.0 until
the final commit in this OpenFlow 1.0 set.
The OpenFlow 1.0 specification supports matching the IP address and
opcode in ARP messages. The datapath already supports this, so this
commit merely exposes that through the OpenFlow module.
NOTE: OVS at this point is not wire-compatible with OpenFlow 1.0
until the final commit in this OpenFlow 1.0 set.
Starting in OpenFlow 0.9, it is possible to match on the VLAN PCP
(priority) field and rewrite the IP ToS/DSCP bits. This check-in
provides that support and bumps the wire protocol number to 0x98.
NOTE: The wire changes come together over the set of OpenFlow 0.9 commits,
so OVS will not be OpenFlow-compatible with any official release between
this commit and the one that completes the set.
When printing a flow, there were two references to "port": one the
interface the packet arrived on and the other the L4 ports. This could
be a bit confusing to new users looking at the output of a command such
as "ovs-ofctl dump-flows". This commit changes the incoming interface
field from "port" to "in_port".
The ability to match the IP addresses in ARP packets allows for fine-grained
control of ARP processing. Some forthcoming changes to allow in-band
control to operate over L3 requires this support if we don't want to
allow overly broad rules regarding ARPs to always be white-listed.
Unfortunately, OpenFlow does not support this sort of processing yet, so
we must treat OpenFlow ARP rules as having wildcarded those L3 fields.
